5 axis rtcp

1 year 9 months ago #318408 by Moutomation

5 axis rtcp was created by Moutomation

Hello,
How should I add RTCP feature to a 5-axis machine with the same joints as the machine in the video?

Please Log in to join the conversation.

1 year 9 months ago #318409 by Aciera

Replied by Aciera on topic 5 axis rtcp

Have a look at
configs/sim/axis/vismach/5axis/table-rotary_spindle-rotary-nutating

Set the nutation angle to 90° and ignore the table rotary.

Please Log in to join the conversation.

1 year 9 months ago #318410 by Aciera

Replied by Aciera on topic 5 axis rtcp

You can also try your luck with the somewhat dated 'bridgemill'
configs/sim/axis/vismach/5axis/bridgemill

Please Log in to join the conversation.

1 year 9 months ago #318521 by Moutomation

Replied by Moutomation on topic 5 axis rtcp

Thanks for your answer. Can Gmoccapy screen be used for this kinematics?

Please Log in to join the conversation.

1 year 9 months ago #318525 by Aciera

Replied by Aciera on topic 5 axis rtcp

The GUI is independent of the kinematics the custom panel on the right side is not strictly required for the functionality.

Please Log in to join the conversation.

1 year 9 months ago #318529 by Moutomation

Replied by Moutomation on topic 5 axis rtcp

thanks a lot,It works fine in simulation. I will try to adapt it to my own system.

Please Log in to join the conversation.

Time to create page: 0.794 seconds