New Computer - Error Launching

forum.linuxcnc.org/49-basic-configuratio...-homing-issue#313114
forum.linuxcnc.org/49-basic-configuratio...eing-behavior#194278
forum.linuxcnc.org/49-basic-configuratio...l-axis-homing#286627

Thanks. I checked the physical wiring and the MESA I/O config. The Limit switches were not patched correctly in I/O config. Was able to successfully home everything.

I just need to adjust the z settings because the spindle isn't going low enough to the table.

HOME_SEQUENCE = -1
on both your Y joints is needed. Refer to homing configuration in the docs.
Sometimes you need to invert the sign of the LATCH_VELOCITY to make it go the right way.