Johansson 60 Radial Drill Press as a mill?

Yah, I hear you! Anyhow, I'm going to take some time to clean it up and use what I can and save/store for later that I cannot.

Looks to be hydraulic feed?

It is an old Hydrotel tracer mill, and yes it is hydraulic feed. They had a later model with a Getty's electronic tracer and drives with screws. If I recall it is around 40 HP and well-built.

I don't know if anyone has run a servo-hydraulic actuator with LinuxCNC. It should work well. The drawback is noise, oil and power consumption.