servo motor for a spindle

More
2 years 2 months ago #309025 by PhilipME
Replied by PhilipME on topic servo motor for a spindle
I think it is not as difficult as I thought.

Almost there

Thank you all

 

Please Log in to join the conversation.

More
2 years 2 months ago #309061 by PhilipME
Replied by PhilipME on topic servo motor for a spindle
here is the wiring for speed mode

 

Please Log in to join the conversation.

More
2 years 2 months ago #309066 by COFHAL
Replied by COFHAL on topic servo motor for a spindle
What is the model of your servo driver?

Please Log in to join the conversation.

More
2 years 2 months ago #309072 by PhilipME
Replied by PhilipME on topic servo motor for a spindle

What is the model of your servo driver?in the attachment 


in the attachment

Thanks

Please Log in to join the conversation.

More
2 years 1 month ago #309106 by COFHAL
Replied by COFHAL on topic servo motor for a spindle
Next Monday I will send you the configuration to use this servo motor as a spindle, I don't have it here at home.

Please Log in to join the conversation.

More
2 years 1 month ago #309107 by COFHAL
Replied by COFHAL on topic servo motor for a spindle
I have another question: what control card are you going to use, mesa or a parallel port?

Please Log in to join the conversation.

More
2 years 1 month ago #309126 by PhilipME
Replied by PhilipME on topic servo motor for a spindle

I have another question: what control card are you going to use, mesa or a parallel port?

I really appreciate your questions

I placed order for mesa 7i96. I should receive it shortly

Do I need another mesa with the 7i96 ?

At this time I only have parallel port .

Good day

Philip

Please Log in to join the conversation.

More
2 years 1 month ago #309132 by COFHAL
Replied by COFHAL on topic servo motor for a spindle
No, you can even use that BOB with the 7i96.

Please Log in to join the conversation.

More
2 years 1 month ago #309217 by COFHAL
Replied by COFHAL on topic servo motor for a spindle
 This is my setup for a lathe that uses a servo motor for the lathe spindle. Hope this helps. is 7z remove .txt


 

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.055 seconds
Powered by Kunena Forum