Here is the manual for my VFD:
workerbeeit.com/H100SeriesManual.pdf
Here is the wiring I have for the SPINDLE header coming off the 7c80 (I am aware that pin 4 is not connected/used, just terminated the wire so it was not hanging loose)
TB5 PINOUT
TB8 PIN SIGNAL WIRE COLOR
1 SPINDLE- BLUE
2 SPINDLE OUT YELLOW
3 SPINDLE+ ORANGE
4 NC BROWN
5 SPINDLE EN- WHITE
6 SPINDLE EN+ GREEN
7 SPINDLE DIR- BLACK
8 SPINDLE DIR+ RED
I am not sure how to wire the enable and direction controls to the VFD
VFD PIN DESC WIRE COLOR
AO ALG. V OUT
GND GND ISOLATED FROM PE
X4
X5
X6/Y1_FO
P12 12V OUT 150mA
AI1 ANLG V IN
AI2 ANLG V IN
GND GND ISOLATED FROM PE
X1
X2
X3
X1-6 are multifunction pins, and can be assigned, but i'm not sure how to wire this (someone on discord mentioned wiring as "single ended"?)
It also appears that this VFD can use ModBUS, not sure if that would be a better option than analog?
The mill also has a 2-wire manual (physical) speed dial (potentiometer) that I would also like to wire up, not sure if that should be wired to the 7c80 or directly to the VFD.
