Version 2.7.3.

Does version 2.7.3 have any built in torch height control features?

It would be really sweet if there were assignable pins in stepconf for up, down and arc ok.

Jog buttons would be nice too. x+ x- y+ y- z+ z- a+ a- and automated support for a second parallel port configured as an input card.

Thoughts?

There is no support for torch height in stepconf.
It seems to me that anything requiring torch height control is a very complicated setup with non common hardware.
if there is common hardware/software that is compatible with stepconf then it could be added.

Job buttons could be added.

None of this will be added to 2.7.x ass that is for bug fixes only.
but 2.7.x does have support for a stepconf parport built it.

Chris M