Stepconf Wiz?..how much does it actually convert

I ran the stepconf wizard on my Mach3 file and it doesnt seem to read all the XML information is this how it is supposed to work?. I had to set all my port pins manually and the units per step and there are a lot of other things it wants to know that I would have thought would have been read from the XML file. Is this correct or do I have a issue?

I wasn't aware that stepconf did any conversion at all

AFAIK this has always been done by JT on the forum here with his conversion utility:

forum.linuxcnc.org/forum/9-installing-li...n-from-mach3-to-emc2

I read it that the wizard took the settings from the XML file and setup LCNC to use those ports and settings

Yes I guess that's correct now (there's a import mach xml file option)
Sorry I cant help with your issue, I'm not sure what parameters it is intended to import