Forum Header

How to find the driver timing?

emad
Topic Author
Offline
Junior Member

9 years 11 months ago #83355 by emad

How to find the driver timing? was created by emad

Hi, I have a 2M542 stepper driver.What are the values of Step Time,Step Space,Direction Hold and Direction Setup in this drawing?

Please Log in to join the conversation.

tommylight
Away
Administrator

9 years 11 months ago #83356 by tommylight

Replied by tommylight on topic How to find the driver timing?

That would be step time of 4 usec total as there is a rise and fall time of 1usec plus 2usec pulse.
So the default of linuxcnc will work properly as it is 5 usec.
I would advise using 15usec from excperience with all kinds of drives.

Please Log in to join the conversation.

emad
Topic Author
Offline
Junior Member

9 years 11 months ago #83357 by emad

Replied by emad on topic How to find the driver timing?

OK, I'll set it to 15usec.Thanks for help, tommy.

Please Log in to join the conversation.

tommylight
Away
Administrator

9 years 11 months ago #83359 by tommylight

Replied by tommylight on topic How to find the driver timing?

You are welcomed.

Please Log in to join the conversation.

Time to create page: 0.175 seconds