Forum Header

StepConf wizard won't convert my Mach3 XML

More
9 years 8 months ago #88369 by Todd Zuercher
Replied by Todd Zuercher on topic StepConf wizard won't convert my Mach3 XML
Sometimes those can be the result of a failed attempt to start Linuxcnc. Reboot and try again, if you still get those then, we'll have to look for other problems.

Please Log in to join the conversation.

More
9 years 8 months ago #88370 by clive
Replied by clive on topic StepConf wizard won't convert my Mach3 XML
OK!

Please Log in to join the conversation.

More
9 years 8 months ago #88372 by clive
Replied by clive on topic StepConf wizard won't convert my Mach3 XML
A reboot did the trick. Thank you so much for your help this morning.

Please Log in to join the conversation.

Time to create page: 0.034 seconds
Powered by Kunena Forum