Forum Header

Step Config setup questions?

9 years 7 months ago #89995 by andypugh

Replied by andypugh on topic Step Config setup questions?

nicokid wrote: I'm curious to know if these usb gadgets work with linuxcnc.

Not for step generation, ever.

Possibly for GPIO, but there is no driver.

Please Log in to join the conversation.

9 years 7 months ago #90033 by nicokid

Replied by nicokid on topic Step Config setup questions?

What a pity, parallel ports are becoming less common.

Please Log in to join the conversation.

9 years 7 months ago #90034 by andypugh

Replied by andypugh on topic Step Config setup questions?

nicokid wrote: What a pity, parallel ports are becoming less common.

I am not sure that they are.

But there are many other interfaces supported by LinuxCNC.
PCI works especially well.

Please Log in to join the conversation.

Time to create page: 0.040 seconds