Forum Header

Parallel port config? - probably

More
8 years 6 months ago #108509 by Gr8funTargets
Replied by Gr8funTargets on topic Parallel port config? - probably
Thanks Todd and andypugh for all your help - it is very much appreciated.

For completeness of the thread I have now had a multimeter on the pins of the parallel port and with the use of the port tester here..
wiki.linuxcnc.org/cgi-bin/wiki.pl?Parallel_Port_Tester
I could prove the parallel port is working fine.

Having achieved this, I have now ordered a new BOB as that is the next link in the chain.

ATB
Danny

Please Log in to join the conversation.

More
8 years 3 weeks ago #118439 by luka_339
Replied by luka_339 on topic Parallel port config? - probably
So does this mean that GA-E3800N motherboard works well with linux cnc? The latency is good ?

Please Log in to join the conversation.

More
6 years 6 months ago #162366 by luka_339
Replied by luka_339 on topic Parallel port config? - probably
I would like to know that aswell

Please Log in to join the conversation.

More
6 years 6 months ago #162367 by luka_339
Replied by luka_339 on topic Parallel port config? - probably
Found my own answer 2 years later :)

Please Log in to join the conversation.

More
6 years 3 months ago #176405 by cadsculptor
Replied by cadsculptor on topic Parallel port config? - probably
Hi Luka,
...and, the answer is?

Please Log in to join the conversation.

Time to create page: 0.050 seconds
Powered by Kunena Forum