Forum Header

Error stepconfig for lathe

More
8 years 5 months ago #111034 by Aleks
Error stepconfig for lathe was created by Aleks
When creating a new configuration, the module Stephen.2..... in the hal file causes an error.

Please Log in to join the conversation.

More
8 years 5 months ago #111082 by andypugh
Replied by andypugh on topic Error stepconfig for lathe
Which version of LinuxCNC?

I assume you mean "stepgen.2..."

Please Log in to join the conversation.

More
8 years 5 months ago #111092 by Aleks
Replied by Aleks on topic Error stepconfig for lathe
LinuxCNC 2.7.13
Yes, stepgen.2....
We have when configuring lathe:
Axis_X
Stepgen.0...(ok)
Axis_Y
Stepgen.1... (absent)
Axis_Z
Stepgen.2... (error)

Please Log in to join the conversation.

More
8 years 5 months ago #111093 by andypugh
Replied by andypugh on topic Error stepconfig for lathe
You can either use stepgen.1 for Z, or increase the number of stepgens in the loadrt line.

Using stepgen1 for axis.2 is the most efficient way.

Please Log in to join the conversation.

More
8 years 5 months ago #111104 by Aleks
Replied by Aleks on topic Error stepconfig for lathe
I'm doing it. Correcting stepgen.2.... on stepgen.1 ... for axix.2
I'm just reporting a bug in the program StepConfig for lathe.

Please Log in to join the conversation.

More
8 years 5 months ago #111259 by andypugh
Replied by andypugh on topic Error stepconfig for lathe
I have moved the topic out of "Russian" and in to "Steconf" where it might get some more attention from the stepconf developer.

Please Log in to join the conversation.

More
8 years 5 months ago #111304 by Aleks
Replied by Aleks on topic Error stepconfig for lathe
Thank you!
Waiting.

Please Log in to join the conversation.

More
8 years 5 months ago #111312 by cmorley
Replied by cmorley on topic Error stepconfig for lathe
confirmed your findings - I will look into as soon as I can.

Chris M

Please Log in to join the conversation.

More
8 years 5 months ago #111313 by Aleks
Replied by Aleks on topic Error stepconfig for lathe
In the version 2.7.12 there is not this problem!

Please Log in to join the conversation.

More
8 years 4 months ago #111359 by cmorley
Replied by cmorley on topic Error stepconfig for lathe
ok pushed a fix for this.
Caused by fixing a bug for: all limits + home option for lathes.
Thanks for the report.

Chris M

Please Log in to join the conversation.

Time to create page: 0.120 seconds
Powered by Kunena Forum