Axis configuration

sorry to keep asking.

Ok my motors are nema 23 and are 200 steps per revolution.

my drivers are kl 5056 and the driver micorstepping is set at 4 micro steps on the driver.

so in the axis configuration in linuxcnc for motor steps per revolution i should use 200
and in the driver microstepping i should us 4, or change the settings on the drivers to 2 and use 2 on the axis configuration?

What is the pitch of your screw?

A 5tpi screw divided by 200 steps is .001 per step. So I think you would want to microstep 10 to get .0001 resolution. I think this is how it works.

At 4 you could step .00025 inch