gmoccappy and stepconf wizard's files

Stepconf wizard creates ini and hal file for only axis. I use parallel port for interfacing motor drivers. Can we rearrange stepconf wizard ini file for gmoccapy and hal file for parallel port?
Thanks in advance who reply this post.

You can pick GMOCCAPY from the step config wizard

Edit to add, on 2.8

In the ini all you have to do is replace the word axis with GMOCCAPY where it says display

yiu may now STEP into PRO USER and
TAKE Editor"gedit" and edit one LINE by HAND

DISPLAY = axis
DISPLAY = gmoccappy

IF there is a PYVCP panel plese unmark it with #
also the postgui HAL of the panel and you are up