Two parallel ports

Formerly on EMC2 you had the option to choose in the "Step wizard conf" the option of using two parallel cards.
Today I need to use two parallel cards and this option does not appear in the Linux CNC wizard.
I have the second card with address "0xe010" and pin 17 is a thread that I want to activate using an MDI command can someone help me how?

gois wrote: Formerly on EMC2 you had the option to choose in the "Step wizard conf" the option of using two parallel cards.
Today I need to use two parallel cards and this option does not appear in the Linux CNC wizard.
I have the second card with address "0xe010" and pin 17 is a thread that I want to activate using an MDI command can someone help me how?

I have just checked and it is in steconf on the base page at the bottom. 2.7.14 and 2.8

you just need to enter bothe adresses in the first entry line
EXAMPLE
0x378 0xe010
thats all
the configuration is the same at it will show 2 parports in stepconf wizard

why need use 0xe010 because all paraller ports use
LPT1: 0x378 (or occasionally 0x3BC) (IRQ 7)
LPT2: 0x278 (IRQ 6)
second port need be 0x278 not other i think.
3th port addres have LPT3: 0x3BC (IRQ 5)
all other addres not working not have.