Linuxcnc - plasma router - joint 2 flolowing error

Hello,


i build the plasma router 1m x 1m. I used LinuxCNC 2.7. and THC by Proma. On webpage Proma is simple config for LinuxCNC.

I used this config and modified the parallel port settings for my machine.

On axis Z i have float_switch and if i ON this switch, then on screen is error - "joint 2 flolowing error"

Can you please some help me, what is the problem ?




Many thanks !

hi
quite a distorting file setup
but its ok
it coudt be all in 2 files

why are the
Zaxis scale 320 steps per mm the driver wont make it at 400mm/sec thats 160000steps per second no way to folow
a plasma Z shoudt have no more then 100 even less 0.01mm on THC is pretty low and you use 0.003mm 3times

you messet up on
setp stepgen.2.dirhold 45000
setp stepgen.2.dirsetup 45000
setp stepgen.2.maxaccel [AXIS_2]STEPGEN_MAXACCEL

Hi,

thanks.
On axis Z is chinese stepper motor without datasheet.


So, I have one next 2phase motor 1.8° with documentation.

On motor is leadscrew M8 with pitch = 2mm/rev.
I use motor driver with microstepping pulse/rev = 1600

How is the scale for axis Z ? It is 800 ?

Please, where i use 0.003mm 3times ?

Thanks

Have a read through howto and thc.hal file, everything is explained there.
For the float switch you already have two lines in thc.hal, just omit one and use the other.

You might want to use one of these configs that best suit your needs, new versions and with detailed direction for editing.

forum.linuxcnc.org/plasma-laser/34978-th...-with-how-to?start=0

Hello Tommy,


great, i check it config today , thank you.

Hello Tomy,

i changed the config from Grotius (i found it in post forum.linuxcnc.org/plasma-laser/34978-th...-with-how-to?start=0) and this is the error :


What is please wrong ?

What version of Linuxcnc are you using ?
That config is for 2.8 or 2.9, it will not work with 2.7 as it has joint/axis info in it.

aahhh, thank you, yeah, i use now 2.7. I upgrade it to 2.8

You are welcomed.