Linuxcnc - plasma router - joint 2 flolowing error

Thanks, mr. Rodw ...i try post processor for sheetcam for Plasmac (i see on this forum )

So, please, can you some send me procedure, how calibrate the THC PROMA 150 ?

Many thanks,

HYS 2
DEL 0.1
H V 240

Hi Tommy, you are best !! . It seems, that THC works !!!. I am very happy ....

Now .... i am newbie user of Sheetcam. I use this post for PlasmaC ( github.com/DenkBrettl/plasmac_sheetcam_postprocessor )

So, i created some G-Code and now i try upload this to LinuxCNC and i have this error.

Why wouldn't you use the post processor from the author of Plasmac?
forum.linuxcnc.org/plasmac/38438-plasmac-post-processors

i don't know,,,,but i try it ......thank you Rodw

Ok, sheetcam is fine, now i have still problem with torch height.

If i cut some small holes, then i have the error " Valid Arc Lost" or "Float Switch Activated Program Paused"

I think, that if i try cutting through small steel plate (thick 2mm), then the problem is more frequent, because the steel still bended.

Maybe some bad settings .....i tried change the 'cut height' from 2 - 4 mm and 'feed rate' from 200 - 2000 mm/min.

If i tried cut for example "STAR" into big steel plate (thick 3 mm), then all is OK.


My last question is : the PROMA THC is set now for 162V. This voltage must be changed for different thick of steel plate or is the stable one value ?

Many thanks,

Additional information: I do not have a water bath yet ...

"My last question is : the PROMA THC is set now for 162V. This voltage must be changed for different thick of steel plate or is the stable one value ?"

Hi, on my Proma SD I change the voltage settings for different thicknesses of steel. For mine with Hypertherm Powermax 45XP using 50:1 voltage divider; 99v for 11 ga, 103v for 7 ga, 105v for 1/4", 110v for 1/2".