Forum Header

UHU Servocontroller

MariusCnc1
Topic Author
Offline
New Member

5 years 3 weeks ago #222644 by MariusCnc1

UHU Servocontroller was created by MariusCnc1

Hello guys!
Anyone knows the timming settings step/dir for the UHU servocontroller from uhu-servo.de/ ?
Thanks !

Please Log in to join the conversation.

tommylight
Offline
Administrator

5 years 3 weeks ago #222645 by tommylight

Replied by tommylight on topic UHU Servocontroller

Start with 5000 for step time and space, leave dir setup at 20000.
Later you can try lowering just the step stuff, leave dir at 20000 as it does not lower the overall speed, but can cause missed steps if to low.

Please Log in to join the conversation.

Time to create page: 0.071 seconds