Latency Test is weak...

Hello everyone,

I guess this Latency Test below very-very bad!!!
Under stepper config axis test the motor lost step if mouse move...  
Please recommend me right PC configuration.

Thank You!

Hi,I'am so sorry, but the pic was wrong!The correct is below.

 

What hardware are you running?

Do you have all power management/cstates>1/Turbo modes/EIST/hyperthreading
disabled in the BIOS?

Hi PCW,

I found this information on PC.
Is that enough or do you need more?
What linux terminal command should I use?

The settings I mentioned are set the BIOS setup screen on the PC, Not Linux

Hi PCW,

You wrote this:"Do you have all power management/cstates>1/Turbo modes/EIST/hyperthreadingdisabled in the BIOS?"

Where i find those (about hyperthrading) BIOS informations?
 (- I start the boot process, 
  - I press F10 for BIOS setup
   - In the BIOS I found this about power management (see the attachement))

What I make wrong?

Thx!

All disabled.

Hi,

I found more informations for my PC,and I have one question:

This processor  on below able for LinuxCnc?

 

It should be OK

Make sure you look for power management options
on all tabs (thermal etc)
 

Pretty sure i have one of those HP in the shop, well i have it for sure as i installed Linux Mint and LinuxCNC on it two days ago, so yes it should work if electronics are OK, and it has a parallel port header on the motherboard that usually comes with the DB25 connector on the back.