Motor locks but will not move when testing

Also completely disconnected enable wires as recommended

Thanks so much for the help!!!!

I cannot believe I am having this much of a problem... this will be the 3rd CNC system I have built... the first in linuxcnc but that shouldn't make this much of a difference...

I figure I have done something dumb or I have a defective piece of hardware.
 

Try to jog with the PGUP/PGDOW keys on the keyboard or the Z axis on screen

Page 4

Control signal amplitude is 24 V as default. If it is 12 V, please set the S2 (Figure 2) selector switch to 5 V first, then
connect 1KΩ resistor; If it is 5V, please set the S2 to 5V.

I don't know if this is it, but worth a try.

 

THAT WAS IT!!

I knew it was going to be something dumb I did.

Thanks to everyone for their help!!!

i have the same problem. change the pin 6 to z direction and pin 7 to z step and it's work for me.