linuxcnc 2.7.14 swap file problem with Clonezilla

I take it you backed up the /etc/initramfs/conf.d/resume file ?

Delete the file with the resume.save and run the command again, there should be no quotation marks used in the file

When using clonezilla, i use it only for disk to disk. That is 8 min.
Keep in mind, cloning can not be done to a smaller target disk.
I am interested in network cloning.

Grotius wrote: Keep in mind, cloning can not be done to a smaller target disk.

Yes it can be done, requires disabling checking for the size of the target, -icds to the command line or selecting that in the advanced mode of the graphical interface.
Important: no relevant data can be located at the block numbers over the number of blocks the target drive has, that will not work for sure.
Several times i used to write an image of a 256GB SSD to a 120GB SSD, but the amount of data was 85GB and all of it was located at the beginning of the drive. I also did from 128GB SSD to 16GB USB over 20 times, all working, only 8.9GB of data.