LinuxCNC + Orange Pi (allwincnc)

What does Archived mean?? no more development, unfinished?? I'm making a big pile of unusable LinuxCNC controllers. RPI4 with Remora got it up and running and found out it's limited to 25khz...#$%@^. ESP32.. Lossing hair over, Bought an H3 board and now the unfinished project is Archived and says don't load current as it will brick the board.. What version should I load? 

Hi Cncninja,

I was runing my pi with Armbian_21.02.3_Orangepipc_buster_current_5.10.21_xfce_desktop.img
You can find them below.
archive.armbian.com/orangepipc/archive/

Hi forks,

Today, I do some search on net and find the method below to install OpenGL on Mali GPU to the system, and I get the better result with no error.
My speed setting is:
MAX_VELOCITY = 150.0
MAX_ACCELERATION = 200.0
SCALE = 1280.0
Even I can not get the glxgears in more then 150 FPS.

Please check the link below for reference :
forum.armbian.com/topic/1420-opengl-on-m...api-orangepi-pc-etc/
linux-sunxi.org/Mali_binary_driver#Device_permission
linux-sunxi.org/Xorg#fbturbo_driver
linux-sunxi.org/User:Rellla/Armbian

SEE, as I mentioned earlier we just need some cleanups and a thorough going over of u-boot and the rt kernel. I am not impressed by the work done over at Armbian. Not sure if most of those devs have abandoned it or what the situation is over there.

So the ALL-H3-cc is all loaded up everything went great then when it asked for the reboot it boots up to " :~$ " any ideas?

ok got into it with
startx

ok so it running and I can cut the Linuxcnc logo no problem, but if I load one of my g codes it just sits there ( linuxcnc post-process fusion360.) and is locked up have to close and re-open.

Hi forks,

I do agree with Bari. We have to do some optimize with Armbian.
I think this project have great value for the people living in the place not easy to get the MESA BORAD.
I'm very appreciate MX_Master done such great job for made it happen.

  Could someone else try the code so i can see if it's the config or the gcode. the system runs the linuxcnc tool path fine but will not run anything I load. 

Hi Cncninja,

T1 M6 is a g-code command that tells the mill to use tool index 1 (see Note above), and M6 tells the virtual machine to go to its tool change position and execute the tool change.
If you don't set to use this funtion, should remove it from your Gcode.