linuxcnc in arm64 architecture for jetson nano w rt-preempt patch

6 years 4 months ago #171583 by hobbyno1

linuxcnc in arm64 architecture for jetson nano w rt-preempt patch was created by hobbyno1

Hi,
Is there an arm64 architecture version of linux cnc for the jetson nano with rt-preempt patch ? if there is not, is anyone developing one ?
thx

Please Log in to join the conversation.

6 years 4 months ago #171683 by bbsr_5a

Replied by bbsr_5a on topic linuxcnc in arm64 architecture for jetson nano w rt-preempt patch

you do not need a patch
just install the standard iso
www.linuxcnc.org/testing-stretch-rtpreempt/

Please Log in to join the conversation.

6 years 4 months ago #171716 by tommylight

Replied by tommylight on topic linuxcnc in arm64 architecture for jetson nano w rt-preempt patch

bbsr_5a wrote: you do not need a patch
just install the standard iso
www.linuxcnc.org/testing-stretch-rtpreempt/

Not an ARM64 architecture that he is asking for.
There is ARMHF here
buildbot.linuxcnc.org/dists/buster/master-rtpreempt/
But no ARM64.

Please Log in to join the conversation.

Time to create page: 0.077 seconds