my own designed 7i92 board not work

PCW wrote:

No, the card should respond to pings regardless of what's in the EEPROM,
because the 192.168.1.121 address is in the FPGA configuration, not the EEPROM.

I suspect a hardware issue. If you set the IP address jumpers to the
bootp setting (Up/Down on a 7I92) does the card transmit once per second?
(this should be visible on the link lights)

Actually I should step back a bit, before you run mesaflash,
have you programmed the FPGA via JTAG? (this is necessary to bootstrap the card)
 

yes! it's transmitting

and I programmed FPGA , in boot the user led blinked

OK, when you ping the card, do the user LEDs count?

yes , but ping show packet loss

It sounds like its transmitting (you can verify with tcpdump)


Are you using a recent bit file?

Bitfiles before May 2018 do not mask the MAC address from the EEPROM
so an uninitialized EEPROM will result in a 0xFFFFFFFFFFFF MAC address
This may result in lost packets if the go through a switch (Bitfiles after May
2018 mask the MS byte so you get a valid MAC address even
berfore the EEPROM is initialized.)

 copied a 7i92?

... but run a fiber laser in another post... yup just for personal use 

robertspark wrote:

 copied a 7i92?

... but run a fiber laser in another post... yup just for personal use 

 

All I can say is that Peter's behavior is really respectable

I would have said amazing and extremely supportive

robertspark wrote:

 copied a 7i92?

... but run a fiber laser in another post... yup just for personal use 

You noticed ...
Although i do understand (probably) as he seems to be living in a country worse than mine (i have my doubts), so getting a Mesa card is pretty much like wining the lottery.

robertspark wrote:

I would have said amazing and extremely supportive

+1

PCW wrote:

It sounds like its transmitting (you can verify with tcpdump)


Are you using a recent bit file?

Bitfiles before May 2018 do not mask the MAC address from the EEPROM
so an uninitialized EEPROM will result in a 0xFFFFFFFFFFFF MAC address
This may result in lost packets if the go through a switch (Bitfiles after May
2018 mask the MS byte so you get a valid MAC address even
berfore the EEPROM is initialized.)
 

I received the code from mesanet and compiled and programmed (with ise)

after trying some idea , I realized the board received packet but not response to them.
i send several packet with UDP sender to board but not know the board ip.
when i send data through ip 192.168.1.255 port 27181 the led blinked (that shows the packet received)
but when send to 192.168.1.121 but Did not answer.