Latency- Test

hi all,

I have a 7i80db16 mesa board.
And I'm using Celeron J1900 2Ghz.

My latency test:

Servo thread: max Jitter: 50000(ns)
base thread(25us) max Jitter 143648(ns)

is This good to run linuxcnc?

Any Bios setting to improve Jitter?

thank you so much

Seems OK, but to know for sure, connect the card to the PC and leave it on for a day or two or more.

If you are going to use a 7i80 then run the latency test without the base thread.

latency-test 1000000

will run a single thread at servo-rate

i got :
Servo thread(1ms) : max interal 1046679 and max jitter : 46679

with this jitter, can my system work normally?

thank you
 

hi

Yes, that is perfectly acceptable.