Bigtreetech new allwinner based CNC board? posable cross use

Bigtreetech has released the CB1 which is a Allwinner-based pin for pin replacement for the pi CM4 they also have PI4 adapter boards and more importantly CNC boards designed to plug pi4 or the CB1 directly. I wonder if any of the allwinner work would cross over or remora. 

biqu.equipment/collections/control-board...ts/pi4b-adapter-v1-0



 

Also there are readily available and cheap

Ive had one for a while now, but Im waiting for a better os image.
Last time I checked, 
there was no support for odd screen resolutions (800x480, 1024x600, etc)
There is no DSI support, so that is very disappointing. 
Dont know if there is SPI drivers for it yet, or if the linuxcnc SPI drivers (hm2/remora) will work. 

Does anyone know if H616 is supported by the allwinner lcnc driver?
I dont know to much about it, and didnt know if H616 counts as H6 

We have to make a better Linux image. Waiting for armbian or similar hell will free over first and it still will need work.
linux-sunxi.org/H616#Documentation

Wish you would have mentioned this board earlier.

Manta M4P/M8P Control Board with CB1/CM4
biqu.equipment/products/manta-m4p-m8p

CB1 Allwinner H616 Linux control board for $27 that plugs into a 4 or 8 axis STM32 Remora controller board Manta 4 ($40) or Manta 8 ($98)

Allwinner H616
linux-sunxi.org/H616#Documentation

STM32Gx
www.st.com/en/microcontrollers-microproc.../stm32g0-series.html