LinuxCNC-RIO - RealtimeIO for LinuxCNC based on FPGA (ICE40 / ECP5)

Please Log in to join the conversation.

Please Log in to join the conversation.

Replied by meister on topic LinuxCNC-RIO - RealtimeIO for LinuxCNC based on FPGA (ICE40 / ECP5)

very strange

i can only test in simulation at the moment, can you try it also in simulation mode please !?!

bin/rio-generator -S carrot.json

Please Log in to join the conversation.

Please Log in to join the conversation.

Replied by meister on topic LinuxCNC-RIO - RealtimeIO for LinuxCNC based on FPGA (ICE40 / ECP5)

many many thanks !

found the problem, fixed in main and dev branch.
please update your gateware.

The PID controller had compensated for the fault during operation, so I never noticed it

Please Log in to join the conversation.

Replied by Tim Bee on topic LinuxCNC-RIO - RealtimeIO for LinuxCNC based on FPGA (ICE40 / ECP5)

Dear meister:

I tested again, Thank you very much

Please Log in to join the conversation.

Please Log in to join the conversation.

Replied by meister on topic LinuxCNC-RIO - RealtimeIO for LinuxCNC based on FPGA (ICE40 / ECP5)

many thanks again

fixed in main/dev

I recently made a modification that only copies the modifier files to the Gateware directory when necessary,
but I didn’t realise at the time that some of the filenames are slightly different (debounce -> debouncer.v / pwm -> pwmmod.v)

Please Log in to join the conversation.

Replied by Tim Bee on topic LinuxCNC-RIO - RealtimeIO for LinuxCNC based on FPGA (ICE40 / ECP5)

Dear meister:

My English isn't very good, so I don't know how to say thank you. Please forgive me.

Tim

Please Log in to join the conversation.

Replied by meister on topic LinuxCNC-RIO - RealtimeIO for LinuxCNC based on FPGA (ICE40 / ECP5)

for the verilog/fpga developer:

Verilator and SDL2 is a good combination

PS: also added an pin oscilloscope function:

 

Attachment not found

 

Please Log in to join the conversation.