TTL trigger output

andypugh
Offline
Administrator

12 years 5 months ago #46761 by andypugh

Replied by andypugh on topic TTL trigger output

gillinderglass wrote: Does it seem right?

Not quite.
I actually prefer the long-form of the net command, it saves space :-)

Code:

loadrt oneshot count=2
...
addf oneshot.0  servo-thread
addf oneshot.1  servo-thread
...
net prog-paused halui.program.is-paused => oneshot.0.in
net take-photo oneshot.0.out  => parport.0.pin-09-out
setp oneshot.0.width 0.01

net photo-done parport.0.pin-10-in => oneshot.1.in
net restart-prog oneshot.1.out => halui.program.resume
setp oneshot.1.width 0.002

Should probably work. (I haven't tested it)

Please Log in to join the conversation.

gillinderglass
Topic Author
Offline
New Member

12 years 5 months ago #46771 by gillinderglass

Replied by gillinderglass on topic TTL trigger output

You are fantastic. Thank you. I wouldn't have ever figured this out.

There is just one error. command - (EMC_TASK_PLAN_RESUME) cannot be executed until the machine is out of E-Stop and turned on.

Regards,
Bart

Please Log in to join the conversation.

andypugh
Offline
Administrator

12 years 5 months ago #46779 by andypugh

Replied by andypugh on topic TTL trigger output

gillinderglass wrote: There is just one error. command - (EMC_TASK_PLAN_RESUME) cannot be executed until the machine is out of E-Stop and turned on.

Can you work round that? It sounds like the oneshot fires immediately, before the system is turned on.

If it is a problem, then take the output of the resume oneshot through an and2 component with something like amp-enable.

Please Log in to join the conversation.

Time to create page: 0.035 seconds