Cutter compensation problem

Hi everyone,

I wanted to build a case for an Arduino project with DXF2Gcode & Qcad, so far so good I loaded the design in LinuxCNC 2.5.4 and clicked on 'Play'.
But I get this error:

I already turned it OFF with G40 at the beginning of the Gcode but that doesn't fixed it at all.

Someone who knows a solution for this?

Cheers,
Dylan

You have G41 or G42 about every few lines with no G40 between them to turn it off.

You should read the User Manual section on cutter compensation.

JT