O-Words to open files

My "GFile1.ngc" contains the following

o<GFile1>sub

G91
G0X30
o<GFile>endsub
M2

My "Test2.ngc" file contains

o<GFile1>CALL
M2

I load Test2.ngc without any problem (in axis) but when I try run, there is no action. No error, no message.
I have tried a few variations. Any suggestions?

Thanks
Greg
Greg

I refer you to this topic to which I previously posted

www.linuxcnc.org/component/option,com_ku...d,1672/lang,english/

As far as I could tell, calling named files does not work ( In 2.3 at least) but calling numbered files works fine.

regards

Arc Eye

Calling named files has worked since 2.3.

Greg, you can't have caps in the called file name.

John

BigJohnT wrote:
Greg, you can't have caps in the called file name.
[/quote]

Indeed. The parser strips out all spaces and converts to lower case, so it is looking for the file "test2.ngc" and not finding it.