G2 and G3 for lathe

More
9 years 4 months ago #94718 by alexandrub
G2 and G3 for lathe was created by alexandrub

Attachment not found

Heloo,

I am trying for 2 days to write a code just for the arc shape of this piece for my lathe but I receive an error thath the radius to end of arc differs to radius to start....please help me with a Gcode for this shape.


Thank you.

Please Log in to join the conversation.

More
9 years 4 months ago #94721 by massimodamassa
Replied by massimodamassa on topic G2 and G3 for lathe
Try this gcode.

Attachment not found

Please Log in to join the conversation.

More
9 years 4 months ago #94723 by andypugh
Replied by andypugh on topic G2 and G3 for lathe
For a lathe arc you need to be careful about radius mode and diameter mode.

Also be aware that in a right-handed coordinate system and a front-toolpost lathe the sense of G2 and G3 is as viewed from underneath.

Please Log in to join the conversation.

Time to create page: 0.084 seconds
Powered by Kunena Forum