M03, M05 showing red in editor

Hi,
First time here! I have my mill now running machinekit on a Beaglebone with GMOCCAPY.

So I can move and start everything using manual and MDI modes. I wanted to write a short program but when I load it and try to run the M03 and M05 commands are blocked red in the editor and the program won't run. I can issue those commands fine in MDI mode however.

Any insight here much appreciated.

Stephen

hi you can get the profile editor
like here

Thanks - I had thought there was an issue with the codes hence the red but it appears they just appear red anyway. I had a couple of other issues with the file but managed to sort them out so that it now runs fine.

Cheers

Nise can you mark the Topic Solved please

How?

soram wrote: How?

Post a reply with solved but also add that to the title, above where you normally write.