Sharing G71 remap

Barry is someone looking to try my version of the g71 remap. I thought it was him showing up. Apparently you are not Barry. Nice to meet you. Note that the four files in this post is my g71 remap. So don't be confused by other posts which may refer to another version of g71 remap. Note that my g71 has some additional features, be sure to try them out too.

With "my version" I don't mean a modified version. I programmed this from scratch.

rider-83 wrote:

github.com/LinuxCNC/linuxcnc/tree/andypu...configs/sim/axis/g71

404 page doesn't exist?
 

It seems that I deleted it when purging my redundant branches. 

I probably didn't mean to. 
 

I've created a folder called 'python' at the location below:

/home/boxford/linuxcnc/python

I have copied into this 'python' folder the files:
remap.py
stdglue.py
toplevel.py
v3.py

My .ini file now contains:

[PYTHON]
TOPLEVEL = /home/boxford/linuxcnc/python/toplevel.py
PATH_APPEND = /home/boxford/linuxcnc/python
[RS274NGC]
REMAP=G71 modalgroup=1 argspec=PDrikjlfst python=g71

But it's not working. LCNC starts up correctly with no errors, but G71 is not yet recognised.

If you start LinuxCNC from the command line do you see any Python messages?

There appears to be nothing relating to python, not even any mention of errors

Working now. I don't know what I did, but after running from terminal it seemed to sort itself out.

Is it possible to install this script into version 2.7.14 ?

viski wrote:

Is it possible to install this script into version 2.7.14 ?

It will probably work, but why are you using 2.7.14 (released June 2018). You should probably update to at least 2.7.15. And 2.8 has been out for 2 years.