g code programs

More
16 years 1 month ago #3979 by ingramf
g code programs was created by ingramf
I recently acquired an isel router with X,Y,Z planes. Does anyone know of any programs for signage, picture carving available?
thank you, Frank

Please Log in to join the conversation.

More
16 years 1 month ago #4024 by andypugh
Replied by andypugh on topic Re:g code programs
image2gcode might be a good start.
www.linuxcnc.org/docview/html//gui_image-to-gcode.html

Please Log in to join the conversation.

More
16 years 1 month ago #4029 by Rick G
Replied by Rick G on topic Re:g code programs
You might also look here..
heeks.net/
Rick G

Please Log in to join the conversation.

More
16 years 1 month ago #4030 by Rick G
Replied by Rick G on topic Re:g code programs
Depending on what you want to do try here..

wiki.linuxcnc.org/emcinfo.pl?Simple_EMC_G-Code_Generators

wiki.linuxcnc.org/emcinfo.pl?Simple_EMC_...t_Engraving_Software

Rick G

Please Log in to join the conversation.

Time to create page: 0.074 seconds
Powered by Kunena Forum