G2 on X,Y and Z

More
16 years 1 month ago #4313 by eddycnc
G2 on X,Y and Z was created by eddycnc
Hi,
I've a question about G2 command.
I need to know if is possible to create an arc on X,Y but at the same time go down with Z axis
how can i do that?

Please Log in to join the conversation.

More
16 years 1 month ago #4314 by radekB
Replied by radekB on topic Re:G2 on X,Y and Z
G00 G17 G90 G21
G00 X10 Y0
Z0
G02 X10 Y0 I-10 J0 Z-5 F500
G02 X10 Y0 I-10 J0 Z-10
G1 X0 Y0
G0 Z25
M2

RADEK

Please Log in to join the conversation.

More
16 years 1 month ago #4325 by BigJohnT
Replied by BigJohnT on topic Re:G2 on X,Y and Z
You might want to read this:

www.linuxcnc.org/docview/html//gcode_main.html#sub:G2,-G3:-Arc

John

Please Log in to join the conversation.

Time to create page: 0.077 seconds
Powered by Kunena Forum