Where do I find the corresponding G-code for Linuxcnc component

For example

motion.digital-out-00 can be triggered by M64 and M65

I will appreciate the slightest hint

Best regards

Philip


 

Can you explain the question a bit more?

All the G-codes are explained here, but I don't think that is what you are asking?

linuxcnc.org/docs/2.8/html/gcode.html

(also in other languages:
linuxcnc.org/docs/2.8/html/gcode_es.html
linuxcnc.org/docs/2.8/html/gcode_fr.html
linuxcnc.org/docs/2.8/html/gcode_vi.html )

Thanks Andy

I am studying the hal for the last few days while waiting for the vfd and other hardware delivery.
I think I have to spend more time to be able to ask questions that make sense.

The link you posted has a column that list the G-code, is there exist a table where a second column that show elements like motion.digital-out-00 next to the g-code , so I know that to change the state of motion.digital-out-00, I need to execute M64/M65

If the question still does not make sense, it means I still have to spend quality time studying to be able to ask the correct question.

Many thanks 

Philip
 

If you follow the link for your m code you should get the detail
linuxcnc.org/docs/2.8/html/gcode/m-code.html#mcode:m62-m65

Also look at M67 and M68 a bit further down

The M64/65 is the g code. In hal you will need to tie that to an output or input for it to work.

Net table-clamp motion.digitial-out-00 => hm2_7i92.0.7i77.0.0.output-15

When you have in your g code::

M64 P0

It will activate the table clamp via that output

Most G-codes do not directly drive HAL pins.

M3 / M4 / M5 control the spindle.N... pins
M19 also has pins for each spindle.
documented here: linuxcnc.org/docs/2.8/html/man/man9/motion.9.html

M7 / M8 / M9 control coolant:
M6 controls tool-change pins
linuxcnc.org/docs/2.8/html/man/man9/motion.9.html

thank you all for the support

I am reading everyday. Was able to execute few examples, hopefully when the hy-vfd arrives, it will look familiar.

The replies above where very helpful.

Thanks

Philip