My Speeds dont work for my M codes.

Hi all

I'm having issues with spindel setup.
The spindel not getting the 0-10v needed to run.

I can get the 7i76U (new) hooked up to old 6i25, to turn the spindel by 
enable HM2_5i25.0.7i76.0.0.spinena-invert (or spinena) 
Upping the xxx.spinout.minlim

But im unable to edit or use xxx.spinout and M codes dont work to start up spindel.

I added firmware "5i25_7i76x2r.bit" to the 6i25 to get the card to read.
And have external 10v supply for the spindel. Took the negative from driver back to the 24v ground.
Seem to have some noise, not sure who it should be hooked up.

It might be the firmware or something Im missing in the hal and ini.
I really dont know. 

I'm unable to edit the xxx.spinout in Halshow to make the spindel spin. Like I think maybe it should be.
Any tips, all this CNC is new for me.

Added hal and ini if anyone would want to look
 

Your hal/ini files did not get attached.

The hal/ini files look basically OK

If you start LinuxCNC, enable the spindle, and set a say 1/2 way up spindle speed

Then running this command in a terminal wndow should provide debug information to post here:

halcmd show all | grep spindle


 

Thanks for you input.
You where correct. Im almost embaressed to tell this.
I turned off the machine and had xmas/new year.

Came back at it was working.
Just needed a good reboot.

But I have a follow up question.
I cant figure out why it gets in to a frenzy when I press stopp.

Must be the driver.
But is there any way to stop this.
in linuxcnc.

youtube.com/shorts/21x_UrOSCuE?si=IMhtfS7cgKt6L2Jk

What is deadband for