Source File For G-Codes

Greetings,

I use LinuxCNC 2.5.4 with AXIS.

When the part program is running, AXIS shows a list of active G-codes. However, when running a G73 cycle, the G73 does not show up. I thinking it may be there but truncated due to limited space.

Now to my real question. Where is the active G-code data stored within LinuxCNC? I would like to view the file with an editor.

Cheers,

Dave

Machine > Show LinuxCNC Status.

JT

Thanks, found the pick in AXIS.

Sadly, the file is constantly updating and it is difficult to keep the screen steady to read the values.

Again, AXIS is a "front end", yes? It reads and displays the data from a root source?

I would like to know the file that AXIS is extracting and displaying the data from.

Cheers,

Dave

it's reading from the Gcode file and any incorporated sub o word macros from your ngc / ngc lib directory
it's quite possible if in a macro , the local values are not displayed . depending on the macro loaded