Setting tabs

Hi guys I could use a little help.
You know the feeling when you can't see for looking?
I had a problem last week which led to a rebuild with no backup, I still can't get to my backup so have to redo everything.
Problem is, I am old and stupid and it took forever to get things how I wanted them last time.
I have the axis working lovely with the probe tab fine but when I try to use the Ncam tab I get a blank panel.
I know I am not pointing the directions in the ini file to the right place but can't think where it should go.

Seems it was updated a couple of days ago but the readme and yotube hasn't been updated to match.
I would rather not use it than try with with poor install instructions.

i will recommend you use clonzilla and make a back up of your full disk as soon as you have the machine working back.

clonezilla.org/clonezilla-live.php

if you prefer you can use
partedmagic.com/downloads/

in the other hand, I couldn't set up the new nCAM release, as you say it is no much info but i think, the required info will be available soon.

Thanks for the reply but backing up is not a problem, get familiar with the dd command and you won't need clonezilla or any special software to do it.
Installing a two day old program with 7 year old instructions is a problem for me.