Axis not doing anything

my axes are running in stepconf when i tested but after that i started axis gui and it does nothing hal shows all pins ok what should i do
also i want to add touch probe in axis or gmoccapy did anyone know how to do it
any help will be greatly aprreciated

if on stepconf all is running AND You SAFED it at the END -> DONE
you may have started the Wrong configuration

if the wizard can run the Axes it may be also a charge pump involved as all pins not configurerd are in high state
and your charge pump will block it

check that simulated hardware checkbox is not checked in stepconf on the START page.

Chris M

thanks sir that helps