M6 probing causes the display to put the extents at the bottom of Z probe depth

I have set up a remap of M6 for probing and I noticed that the extents lines on the toolpath display are set way down in Z. After much experimenting I realize it sets the extents at the bottom of the probe depth limits. I really want the extent display lines to be at g54 Z0 (datum point).

Ideas?

Thanks,
Kent

I am pretty sure i have read this same message earlier today, or ?
Sorry i can not help as i never used probe for mills, mainly use plasma machines.

I am guessing maybe this problem is unique to me? Nobody else has encountered the Z- extents display at the bottom of the probe depth? My probe is lower than my table...

Thanks
Kent