How do I modify an existing creation into a simulation?

Good morning everyone

I have a running machine configuration, so my problem now is that if I want to see how the machine behave after some modification I have fire up my machine to do the test.

I would like to run my machine configuration as a simulator, with my macros and all my own features.
Can someone point me in the right direction?

Thanks in advance for any help.

Regards,
V.

This is the second or third topic you started with the same subject and question, i am sure it got answered before.
No double/triple posting, please.

Hello Tommy

At the present I can visualize 9 open post including this one.
I was looking at this link link but I did not understand.
I copy the title of the post in the link in my new topic so you probably had found two copies, I apologize, my fault.
I will have a look if I can find more info on this topic.

Regards,
V.

Good morning

I solve my problem, just copy from sim a gantry configuration, than went inside and modify the ini file with the figures of my running machine configuration.
All good.

Regards,
V.