Small fix for axis.tcl

More
4 years 11 months ago #226343 by D.L.
Small fix for axis.tcl was created by D.L.
Hi,
I made a little fix for Axis interface:
 

Attachment not found


axis.tcl:
Code:
Orig: pack ${pane_top}.ajogspeed.l0 -side left pack ${pane_top}.ajogspeed.l -side left pack ${pane_top}.ajogspeed.l1 -side left pack ${pane_top}.ajogspeed.s -side right ... pack ${pane_top}.jogspeed.l0 -side left pack ${pane_top}.jogspeed.l -side left pack ${pane_top}.jogspeed.l1 -side left pack ${pane_top}.jogspeed.s -side right ... pack ${pane_top}.maxvel.l0 -side left pack ${pane_top}.maxvel.l -side left pack ${pane_top}.maxvel.l1 -side left pack ${pane_top}.maxvel.s -side right Fix: pack ${pane_top}.ajogspeed.l0 -side left pack ${pane_top}.ajogspeed.s -side right pack ${pane_top}.ajogspeed.l1 -side right pack ${pane_top}.ajogspeed.l -side right ... pack ${pane_top}.jogspeed.l0 -side left pack ${pane_top}.jogspeed.s -side right pack ${pane_top}.jogspeed.l1 -side right pack ${pane_top}.jogspeed.l -side right ... pack ${pane_top}.maxvel.l0 -side left pack ${pane_top}.maxvel.s -side right pack ${pane_top}.maxvel.l1 -side right pack ${pane_top}.maxvel.l -side right
 

Please Log in to join the conversation.

More
4 years 11 months ago #226905 by andypugh
Replied by andypugh on topic Small fix for axis.tcl
Are you able to make a pull request on GitHub?
(Fir a single file change like this you can make the edit live in the web site. But you would have to register )

Please Log in to join the conversation.

More
4 years 11 months ago #226921 by D.L.
Replied by D.L. on topic Small fix for axis.tcl
I did it: github.com/LinuxCNC/linuxcnc/pull/1387
and for 2.7 and 2.8

Please Log in to join the conversation.

Time to create page: 0.200 seconds
Powered by Kunena Forum