Enabling coolant controls

What is necessary to activate the coolant controls in axis?

net coolant-on to whatever pin controlls the coolant pump.
There is also
net coolant-mist
Do check those, on the phone so that is from memory.

Thank you. May be, i did something wrong.
In my hal-file i connect
net coolant-on gladevcp..hal_tstbtn  hm2_[HOSTMOD2](BOARD).0.7i77.0.0.putput-05
and
net coolant-mist gladevcp..hal_tstbtn2  hm2_[HOSTMOD2](BOARD).0.7i77.0.0.putput-04

The pins are working correct, but no checkbox appears on the tab.

 

I can't quite remember the details but axis needs to sense you have a spindle on your machine via hal somewhere. SOmebody might remember the details..

Probably halui...
On the phone so not much help, but make a new test configuration with the wizard, chose the coolant pins, save, then open both hal files from the test config and your working config, use the search function to find any mention of coolant and check the deferences.

Ok, thank you, this helps!

In the hal-file there should be exactly:

net coolant-mist <= iocontrol.0.coolant-mist
and
net cooland-flood <= iocontrol.0.coolant-flood
(Of course, "<=" isn't necessary.)