Manual mode AXS

More
2 years 10 months ago #288614 by tomala89
Manual mode AXS was created by tomala89
Is it possible to set AXIS to automatically change manual mode to automatic mode when the axis is moved in any direction after pressing the arrow key?

Thanks

Please Log in to join the conversation.

More
2 years 10 months ago #288878 by andypugh
Replied by andypugh on topic Manual mode AXS
This _might_ be possible using tha .axisrc file.
There is a thread on this forum about Axis modifications, which might provide some clues.
forum.linuxcnc.org/21-axis/29735-axis-modifications

Please Log in to join the conversation.

Time to create page: 0.076 seconds
Powered by Kunena Forum