How to refresh the Axis screen after setting offsets G10 L20

Hi all,
I have a home-made pendant that can jog and set the offsets using HALUI commands.
When I set the G54 offsets (using HAL commands) I would like to refresh the Axis display so that it will show the part in the offset position.
I would like to use a HALCMD to refresh the Axis display if possible, but will use whatever is required.
Is this even possible?

Thanks in advance.

Not sure if there is a halcmd to do that but you can use an executable custom Mcode to call a bash script that executes this:

www.linuxcnc.org/docs/html/man/man1/axis-remote.1.html

I use M codes for this kind of stuff also. For example M130.

github.com/hausen8/EasyProbe/blob/v2.0/nc_files/M130

Use with:
M130 P255

I am not sure right know, but I had something in mind while writing  "&".
Also some sleeps are always a good idea. Sometimes it gets lost otherwise.

Best regards
Julian

Not really what I wanted, but I think it will work.
Thanks for the link to the example code.
Thanks for your help.

Thanks. With you and juliankoenig and the links, I have plenty to work with.
I really appreciate you guys taking time to reply and share your knowledge.

This should work for 2.8 and up, notice the hal command at the end for refreshing the Gremlin (plotter).

This should work for 2.8 and up, notice the hal command at the end for refreshing the Gremlin (plotter).

Not sure where you got that information from but I don't see an 'axisui.refresh' pin:

 

PlasmaC uses it, i have it on several machines in daily use, so might be there....
Just checked the 2.10 on this PC, not there either...

This turned strange so i fired one of the laptops with 2.8.4 and sure enough it is not in Axis but it is in PlasmaC Axis as cane be seen in the attachment.
This should be included in normal Axis, although rarely needed, it is a good feature to have

yeah its a pin phil added in the plasmac usercommand file
github.com/LinuxCNC/linuxcnc/blob/master...c2/plasmac2.py#L5689