Problems with feed-override

Ich hab die ganze verstehen, aber ich brauche das noch nicht.
This is with no google trans......stroy-ing !!! :laugh: :laugh: :laugh:
MFG,
Tom

Hi,
I am new linuxcnc user, i am going to use motion.adaptive-feed and control by parport.1.pin-10-in for feedback control axis, after many research i figured out by motion.adaptive-feed.

any body can help in this issue.
Regrads

This sounds like it won't work as you describe it.
motion.adaptive-feed is expected to be a fraction between 0 and 1 (or -1 and +1 for the experimental reverse-feed branch)

A parallel port pin is either on or off. Or do you intend to feed a PWM into the parport pin?