Solved - Endstop error after setting HOME SEQUENCE 0-1-1

As long as I have the homing sequence on 0-1-2 everything is ok.
If I change it to 0-1-1 comes an Endstop error message.
Does anyone know advice?

Do both "1" axes share a limit switch input?

There are INI file entries for "HOME_IGNORE_LIMIT" and "HOME_IS_SHARED" that might need to be set.

linuxcnc.org/docs/2.7/html/config/ini-co...s__lt_num_gt_section

No, every axis has its own switch and its own input pin..

Is the home switch also the limit switch? If it is then you do need HOME_IGNORE_LIMITS

But I think that there might be a bit of a bug where the system only ignores some limits if more than one axis is moving. Pnnconf seems to do some clever stuff with a lut5 component to get round this (I am fuzzy on the details here)

I remember from Stuttgart that setting the HOME positions uneven to 0.0 to release the switches was part of the solution.
Mike

Relocating the home position from the switch solved the problem