Servo doesn't react

Hello everyone,

I'm trying to run MDS5015 with ethercat. I created .xml .ini and .hal file on the example swm-fm45a. Windows of linuccnc is opening but servo doesn't react. I don't know what i do wrong. I was looking for a solution on the Internet but I didn't find anything.

Please for any help.

I'm sorry for my mistakes but my English is not very good.

You better look inside the HALMETER
to show if your pins are doing what they suposed to do
is the wirering checked twice ?

Hi,
I have my asda connected to the linuxcnc. and the lcec is also fine.
Could you give me some advice that how to make it run, for example, how to give it a velocity or a positon?
Thanks, best regards!