I want a physical on/off button on my control panel. The behavior I am getting is push-on, release-off. Can someone tell me what I am doing wrong?
Code:
# ##################################################
# matrix keypad
# ##################################################
loadrt matrix_kb config=8x8
loadrt debounce cfg=17,6
loadrt toggle2nist count=1
addf matrix_kb.0 servo-thread
addf debounce.0 servo-thread
addf debounce.1 servo-thread
addf toggle2nist.0 servo-thread
net keypad hm2_7i96.0.7i73.0.0.keycode => matrix_kb.0.keycode
setp debounce.0.delay 10
setp debounce.1.delay 5
net key23todebounce matrix_kb.0.key.r5c0 => debounce.0.16.in
net enablebutton debounce.0.16.out => toggle2nist.0.in
net is-enabled halui.machine.is-on => toggle2nist.0.is-on
net enableon halui.machine.on <= toggle2nist.0.on
net enableoff halui.machine.off <= toggle2nist.0.off
I have checked the signals using the HAL scope and it appears to be sending a single pulse. I can get it to "catch" in the toggled state by hitting the button quickly, but it will usually quite reliably turn on for the duration of the button press, then turn off as soon as I release it.
